Eberg FANTO 120 - Remote Control; Battery Replacement in Remote Control

FANTO 120EN
13
www.eberg.eu
REMOTE CONTROL
BATTERY REPLACEMENT IN REMOTE CONTROL
Turn ON / OFF button
Turn o screen button
Fan speed selection button
Ionizer function button
TIMER mode button
Oscillation function
button
To replace the battery in the remote control, slide out the guide of the battery, remove the old
battery, then insert the new battery in the same place and slide the guide until the latch clicks.
One battery is needed to power the remote control, model No. CR2025 (3V). We recommend
using a lithium battery for extended use.
When the battery runs out, follow the disposal instructions on the battery pack.
PUSH
OPEN
ON/OFF
TURN OFF SCREEN
SWING ION TIMER
SPEED