Eberg HUMI - Installation of the Descaling Filter; Cleaning and Maintenance; Storage

21
www.eberg.eu
HUMIEN
9. CLEANING AND MAINTENANCE
10. STORAGE
The device is equipped with a water softening lter. It is mounted to the lid of the water tank.
• The lter is removed from the lid for replacement with a new one by turning clockwise. After turning,
the lter will be unlocked and disconnect from the age.
• The new lter is installed by sliding the lter into a round socket in the tank lid and turning the lter
counterclockwise. After proper installation, the lter should be blocked in the lid of the water tank. The
lter should not move.
If the device will not be used for an extended period of time, please ensure that it is properly stored.
• Empty the water tank and make sure that there is no water left in the tank and inside the machine.
• Leave the tank and the device to dry naturally and completely before storage.
• Place the device in the original box and store in a cool, dry place.
ATTENTION: The humidier may clog or not work properly if stored without being completely dry. Make
sure the humidier is completely dry before storage.
Because of the risk of electric shock, always disconnect the power
supply and pull out the plug before cleaning work.
• Unscrew the tank cap, pour out the water, wipe the sediment with
a soft cloth and rinse it with clean water.
• Clean the tray once a week. Wipe o the residue with a soft cloth
moistened with a cleaning agent, then wash it with water.
• The humidier housing should be cleaned with a soft cloth rinsed
in warm water and then wiped dry.
• Cleaning the spray nozzle. If there is sediment on the surface,
clean it with a cotton swab, and then wash it with clean water.
• Cleaning the PTC heating element (preferably once a week). If
there is sediment and dirt on the surface of the PTC heater, wipe
o the tarnish with a cotton swab or soft cloth, and then wash it
with clean water.
8. INSTALLATION OF THE DESCALING FILTER