26
27
SET COUNTER (TRIP) TO 0
CRUISE CONTROL
At the same time press both buttons, the center and bottom buttons for a
few seconds.
Turn the throttle grip (right on the handlebar) until you reach the desired
speed, then hold that speed and press the down arrow on the control
panel for a few seconds until you see on display the sign of the cruise
control (on top), then release the acceleration handle and the speed will be
maintained.
To deactivate the speed regulator, press the brake lever.
Your ebGO CC48 / CT48 has been checked just before shipping so
that you have an electric bike in good condition.
To complete the installation, you only have to install the pedals and the
stem. You can also adjust the height of the handlebar and the position of
the saddle for optimal comfort.
For an ideal positioning, we recommend you go to a bike retailer and they
will take care of you.
COMPLETING THE INSTALLATION
EBGO-Guide 2019-EN-V7.indd 26-27 2019-04-17 16:46
To Next Page
Loading...