September 2012 IPV6833
3.1.3 Upgrade Device Firmware
If you want to upgrade the camera, please upgrade Device Firmware first, then upgrade Web UI.
Click Browse and choose correct bin file, then click Submit to do upgrading.
NOTE: Before doing an upgrade via Browser, please make sure the IP Camera Tool of your computer could
find the camera’s IP.
Attention: Please keep the power on during upgrading, and it’s better to use wired mode via network cable.
Please don’t upgrade unnecessarily, wrong operation or incorrect upgrade bin file can damage the
camera.
Figure 5.4
3.1.4 Restore Factory Settings
Click Restore Factory Settings, will pop-up a prompt, select OK, all the parameter will be returned to factory
settings, and the device will reboot.
Figure 5.5
To Next Page
Loading...