Need help?Do you have a question about the EBS REIDMAR 750 and is the answer not in the manual?
Provides a full-bodied, warm, and transparent tone with EBS's renowned compressor, XLR-output, 4-Band EQ, and Drive.
Step-by-step instructions for unpacking, connecting, powering on, and setting initial gain for the bass head.
Guidance on using EQ, Character filter, COMP/LIMIT, BRIGHT, and DRIVE controls to shape the bass tone.
Low noise, high impedance instrument input for passive and active instruments.
Preshaping filter operating independently, boosting bass/treble and slightly dropping midrange.
Adjusts instrument signal strength to the correct operating level, using a PEAK LED indicator.
A fast compressor/limiter that tightens sound and prevents peaks, with adjustable compression ratio.
Activates the filter section, allowing for tone shaping adjustments.
Includes Bass (shelving), Middle (bandpass with frequency control), and Treble (shelving) filters.
Advanced high pass filter for bright treble timbre without adding noise.
Controls gain in the tube emulation stage for overdrive and compression at higher levels.
Controls overall unit volume for the poweramp and LINE output.
Indicates the power on condition of the amplifier.
High quality line box for connecting to PA consoles or recording units; unaffected by volume.
Disconnects ground from the balanced output to eliminate ground noise and hum.
Selects signal source: overall sound (Pre) or after EQ (Post).
Fullrange output for driving multiple poweramps, taken after the volume control.
Connect footswitches to control Character, Filter Active, Drive, and Mute functions remotely.
Connect speakers here; minimum total impedance must not be lower than 4 ohms.
Controls temperature; ensure ventilation openings are not covered.
Selects operating mains voltage; unplug amp before changing.
Accepts stereo/mono 3.5mm plug for mixing external sources; volume controlled by source.
1/4" stereo contact for connecting headphones.
Serial loop for external units like pedals or rack effects, placed after filter/compressor/drive sections.
Connect to indicated mains AC voltage; replace fuse with the same type and value.
Switches the amplifier unit on or off.
Details input impedance, gain range, peak LED behavior, and frequency response.
Provides filter types, gain ranges, and frequency response for Character, Bass, Middle, and Treble filters.
Details compressor gain, attenuation, ratio, attack/release, and drive section gain range.
Specifies balanced output level, XLR connections, effect loop levels, line out, and headphone/aux inputs.
Includes power amp output, minimum load, protection features, power requirements, and dimensions/weight.
To Next Page
General
