Do you have a question about the ecactus WH-SPHA3.6H-5.12kWh and is the answer not in the manual?
Overview of the WH-SPHA series hybrid all-in-one battery energy storage system.
Introduction to safety precautions and warning signs for the BESS.
Explanation of warning symbols used in the manual for safety.
Critical safety instructions for installation, operation, and maintenance of the BESS.
Details of all items included in the BESS packaging for different models.
Visual overview of the BESS, including key components and LED indicators.
Disclaimer regarding manufacturer's liability for product damage or loss.
Guidelines for selecting a suitable installation site for the BESS.
Specifies locations where the BESS must not be installed due to safety or operational reasons.
Requirements for non-combustible barriers when installing near living spaces.
Rules for selecting the optimal mounting location for BESS protection and maintenance.
Step-by-step guide for unpacking and installing the battery box and inverter box.
Detailed instructions for installing the battery box, including tools required.
Step-by-step guide for installing the inverter box onto the battery box.
General guidelines and specific procedures for connecting cables to the BESS.
Initial safety checks before making cable connections.
Recommended cables and terminals for connecting the inverter and battery boxes.
Diagrams showing system wiring configurations with different meter types.
Information on mounting and connecting the electricity meter for measurement.
Requirements for external isolation devices for PV array ports, especially for Australia/New Zealand.
Explanation of DRED usage for demand response modes in Australia and New Zealand.
Step-by-step guide to safely power on the BESS.
Step-by-step guide to safely power off the BESS.
Procedures and first aid measures for emergency scenarios involving the BESS.
Prerequisites for configuring eCactus and reloading Wi-Fi, including required hardware and software.
Procedures for resetting and reloading Wi-Fi settings for the eCactus system.
Confirmation steps for properly installing the left and right side plates of the BESS.
Instructions for cleaning the BESS case using appropriate methods.
Guidelines for maintenance and charging intervals for long-term storage of the battery.
Technical specifications for the All-In-One spec. Series name: Agave.
Information regarding the label on the inverter, including safety and approval markings.
Details of the label affixed to the battery, including specifications and certifications.
| Model | WH-SPHA3.6H-5.12kWh |
|---|---|
| Capacity | 5.12 kWh |
| Nominal Voltage | 51.2V |
| Nominal Capacity | 100Ah |
| Type | LiFePO4 |
| Cycle life | 6000 cycles at 80% DoD |
| Protection | Overcharge, Over-discharge, Over-current, Short circuit, Over-temperature |