ECCB OUTDOOR Outer Banks Value Series User Manual

966 Perry Highway, Mercer, PA 16137 • Phone (800) 687-5086
ECCBOutdoor.com
Congratulations on the purchase of your
new Outer Banks Value Line Poly Lumber
Adirondack Chair. You will soon be sitting
back and relaxing in the comfort of this
classic chair when you follow these
easy step-by-step instructions.
Important
Please Read All Instructions Carefully Before Assembling This Product
• Inspect all parts to make sure that nothing is broken or missing. If something is broken
or missing, please contact our service department at support@eccboutdoor.com.
• The chair must be completely assembled before attempting to use it. Failure to do so
could result in damage to the chair or the user.
• Use proper safety gear and follow appropriate safety precautions when assembling this product.
• Important - Do not overtighten the screws.
• Only hand tools should be used for assembly. Do not use power tools.
• ECCB Outdoor will not be liable for any injury or damage resulting
from improper assembly and/or use of this product.
• Failure to follow all instructions will result in the product warranty being voided.
Assembly Instructions
Outer Banks Value Line Adirondack Chair
ECCB
OUTDOOR
V1

ECCB OUTDOOR Outer Banks Value Series Specifications

General

Brand	ECCB OUTDOOR
Model	Outer Banks Value Series
Category	Indoor Furnishing
Language	English

Summary

Important Assembly Information

Safety and Pre-Assembly Guidelines

Read all instructions carefully, inspect parts, use safety gear, and avoid overtightening screws.

Product Parts and Hardware

Component and Hardware Identification

Lists all chair parts (Back, Seat, Arms, Brace) and hardware (Bolts, Screws, Washers, Nuts).

Hardware Assembly Tip

Instruction to start metal part screwing onto bolt/screw first for proper assembly.

Tools Required for Assembly

Details provided and not-included tools for assembly.

Assembly Steps

Step 1: Attach Brace to Seat

Attach the brace to the seat using bolts, washers, and nuts, repeating on each side.

Step 2: Attach Back to Seat

Line up the back's movable joints with the seat's rear holes and attach.

Step 3: Attach Arms

Attach arms to the back using lag screws, then to the brace using hardware.

Product Care and Maintenance

Cleaning and Tightening Instructions

Clean with a soft cloth and mild soap; periodically check all screws for tightness.