Ecco 21 Series - Page 12

Arrowstik Flash Pattern Selection
The CC Series Lightbar is designed to offer user selectable trafc directing and trafc warning ash patterns. Each of the ArrowStik® func-
tions (LEFT, CENTER-OUT, RIGHT and FLASH) can be programmed individually for unique patterns and ash rates. This allows the greatest
exibility when controlling the various Lightbar congurations available. A Lightbar may be wired as a 5, 6, 7 or 8 light head conguration. The
Lightbar will come from the factory with the Building Fast ash pattern as the default for LEFT, CENTER-OUT and RIGHT. The default pattern
for FLASH is Drivers Side Cut – Front, corner & alley.
When selecting a ash pattern for one of the four Arrowstik functions, apply power to the lightbar and the desired function wire (listed in Table
2). Briey touch the Pattern Select wire (RED/BLK) to +power to cycle through the ash patterns shown in the table below. Ensure power
isn’t applied to any other function wire during ash pattern selection.
Flash patterns marked with an asterisk (*) can be selected in Fast, Medium or Slow ash rate.
Arrowsik Left, Center-Out &
Right Flash Patterns
Order Flash Pattern
1 Building*
2 Building, 3-Flash*
3 Traveling Ball, 3-Flash*
4 Build/Collapse*
TABLE 12
Arrowstik Flash Patterns
Order Flash Pattern
1 Drivers Side Cut - Front corner & alley
2 Drivers Side Cut - Rear corner & alley
3 Drivers Side Cut - Front outboard, corner alley
4 Standard Flash*
5 Quad Flash Standard
6 Simultaneous Flash*
7 Quad Flash Simultaneous
8 Even/Odd Flash*
9 Quad Flash Even/Odd
10 Left/Right Flash*
11 Quad Flash Left/Right
12 Travelling Ball Flash*
TABLE 13
To restore the Factory Default ArrowStik Flash Patterns, hold the BLK/RED and desired function wire to +power for ~four seconds.
Takedown, Work and Alley Light Flash Pattern Selection
When selecting a ash pattern for one of the Takedown/Work Light or Alley Light Modes, power-up the light bar and apply power to the
Takedown Flash Mode (BLK) or the Alley Flash Mode (BLU/WHT). Programming will not work if more than one function is selected. Touch
the Pattern Select wire (RED/BLK) to +power to cycle through the ash patterns shown in the table below.
Takedown, Work & Alley Light
Flash Patterns
Order Flash Pattern
1 Medium Single 115
FPM
2 Slow Single 60 FPM
3 Fast Double 115 FPM
4 Slow Double 60 FPM
5 Fast Six 80 FPM
6 Slow Six 60 FPM
7 Variable Rate - Single
8 NFPA Quad 75 FPM
9 Cycle Flash
10 Fast Quad 80 FPM
11 Slow Quad 60 FPM
12 Fast Single 375 FPM
TABLE 14