Ecco 21 Series - Page 9

The module groups in each mode come with the default ash patterns shown in TABLE 4.
To change a light head group ash pattern selection:
1. Power-up the Lightbar and apply +power to the level mode wire you wish to change (see TABLE 3). The lightbar will ash the default
pattern shown in TABLE 4.
2. Twist together the BLK/RED Pattern select wire in the 16 conductor cable and the wire of the light head group you want to change shown
in TABLE 5.
3. Momentarily touch the BLK/RED and group wire from step 2 to power to cycle through the patterns in TABLE 6. The pattern
for the set of light heads congured will only be set in the level mode selected.
TABLE 4
Level Mode Default Flash Patterns by Group - Unsynchronized
Light Head
Module Group L1 L2 L3
Front Outboard Off Quad 75 FPM Cycle Flash
Front Inboard Off Quad 75 FPM Cycle Flash
Front Center Off Quad 75 FPM Cycle Flash
Front Corner Off Quad 75 FPM Cycle Flash
Rear Outboard Quad 75 FPM Off Cycle Flash
Rear Inboard Quad 75 FPM Off Cycle Flash
Rear Center Quad 75 FPM Off Cycle Flash
Rear Corner Quad 75 FPM Off Cycle Flash
Rear End Quad 75 FPM Off Cycle Flash
L1 + L2 L1 + L3 L2 + L3 L1 + L2 + L3
Front Outboard Quad 75 FPM Cycle Flash Cycle Flash Cycle Flash
Front Inboard Quad 75 FPM Cycle Flash Cycle Flash Cycle Flash
Front Center Quad 75 FPM Cycle Flash Cycle Flash Cycle Flash
Front Corner Quad 75 FPM Cycle Flash Cycle Flash Cycle Flash
Rear Outboard Quad 75 FPM Cycle Flash Cycle Flash Cycle Flash
Rear Inboard Quad 75 FPM Cycle Flash Cycle Flash Cycle Flash
Rear Center Quad 75 FPM Cycle Flash Cycle Flash Cycle Flash
Rear Corner Quad 75 FPM Cycle Flash Cycle Flash Cycle Flash
Rear End Quad 75 FPM Cycle Flash Cycle Flash Cycle Flash
Light Head Group Wires - Unsynchronized
Function Wire Color Light Head Group
GRN/WHT Front Outboard
BLU/BLK Front Inboard
ORG/BLK Front Center
GRN Front Corner
BLK/WHT Rear Outboard
RED/WHT Rear Inboard
BLU/WHT Rear Center
BLU Rear Corner
BLK Rear End
TABLE 5