GB
19
OPERATING INSTRUCTIONS
Charging
1. Make sure that the fabric shaver is switched o before charging
it.
2. Insert the connector of the adapter cable in the charging
connector of the fabric shaver. Plug the power adapter in the
electrical outlet of corresponding voltage and frequency.
3. The fabric shaver should be charged for 8 hours prior to rst use.
4. The blue charging indicator light is lit during charging.
5. This fabric shaver allows operation with power cord or cordless, therefore it can
be used while being charged.
Using the fabric shaver
1. Switch the fabric shaver on.
2. Put the fabric from which you want
to remove lint and pills on an even
surface and smooth it out. Use
without the distance ring is possible
only in case of very ne fabrics, because the pills are shaved very close to the
surface.
3. In the case of coarser woollen fabric, attach the distance ring to the head of
the fabric shaver so that it locks securely to the head of the fabric shaver. The
distance ring can be set in three di erent positions:
1: For ne fabrics, very close shave
2: For coarser fabrics, close shave
3: For coarse fabrics the farthest possible distance from the
fabric
MAINTENANCE AND CLEANING
Cleaning
1. Switch the fabric shaver o .
2. Remove the distance ring.
3. Unscrew the protective screen of the
blade unit.
4. Remove the blade unit (be careful, the
blades are very sharp!)
5. Using the supplied brush, clean the
protective screen, the blade unit and the rotating spindle.
6. Empty the waste bin.
7. Reassemble all the parts in reverse order.
To Next Page
Loading...