EasyManua.ls Logo

ECG PM 3151 - Using the Appliance

ECG PM 3151
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
33
EN
USING THE APPLIANCE
Never use the appliance without the attached cleaning pads.
Never use the appliance with empty water tank.
Do not over ll the water tank to prevent an undesirable increase in pressure.
Do not point the appliance at other people, animals or electrical and electronic devices.
Do not use on leather, waxed and polished furniture, non-impregnated wood, synthetic fabrics, velvet or
other delicate steam-sensitive materials.
Do not use on non-impregnated wooden  oors or  oors made of cork tiles, because the heat and steam
may damage these surfaces. Be cautious when using on laminate  oors and use the lowest steam setting.
Test it always on a small area of the  oor before using it on the whole area.
Never apply the steam too long on one place. The surface of the  oor may be damaged.
Be especially careful when applying it to PVC  oors, linoleum or any other heat sensitive materials. Too
much heat could melt the adhesive of the  ooring.
Do not use on the carpets without inserted carpet attachment.
Never pour hot water in the water tank or any other liquids, for example aromas or preparations containing
alcohol or detergents. The operation in such a case would not be safe and could cause damage to the
appliance.
CDE
FG
Lowering the handle
Lift the handle up and lock it in place. When you want to lower the handle again, press two locking buttons [C]
and push the handle down [D]. Use the handle [E] to lift and carry the appliance.
Filling the water tank
Before  lling with water, make sure the mop is disconnected from the power supply. Remove the tank plug and
using the measuring cup  ll the water tank with clean, cold water and replace the plug [F].
Note: The water tank is completely removable in case that you prefer  lling the removed tank. See following
instructions.
Water tank removal
Make sure that the mop is disconnected from the power supply prior to removal or installing the water tank.
Remove the water tank by pulling upward. Remove the water tank and its base [G],  ll the tank or empty it and
return it in place.