GB
20
INSTALLATION
Make sure the package contains all parts necessary for assembling the convector. Contact your vendor if this
is not the case.
Package contents:
1. Heat convector: 1 piece
2. Base: 2 pieces
3. Attachment screws: 4 pieces
4. Operating manual: 1 piece
5. Assembly kit for wall attachment
Unplug the device, prior to any form of manipulation, to prevent injury by electric shock.
WARNING: Under no circumstances should you operate the heater standing without the base attached.
Installation requirements
Place the convector on a at surface with a su cient amount of space around the appliance to ensure the
proper function of exhaust vents
The distance between the device and surrounding objects must be at least 90 cm.
CAUTION:
To prevent the device from overheating, do not cover the heater.
The heater must not be placed directly under an outlet.
DO NOT COVER!
WARNING: Some parts of this product can become very hot and cause burns. Special attention has to be
paid in the presence of children and handicapped people.
Base
Attachment screw:
1. Place the convector on a at surface.
2. Press the base pegs into the holes found on the bottom part of the convector.
To Next Page
Loading...
