ECG ZV 45 mini - Using the Appliance; Cleaning and Maintenance; Technical Data

19
GB
USING THE APPLIANCE
1. Place the straightener on a  at heat-resistant surface and make sure the surface does not touch the
straightener plates.
2. Plug the straightener into the electric outlet and switch ON via the switch 1.
3. Wait about 5 minutes until the straightener warms up.
4. Work with locks that are about 5 cm wide and half acentimetre thick.
5. Place your hair between the straightener plates and press  rmly. Leave the straightener closed for ashort
while and then slide down your hair from root to end, while ensuring your hair is always stretched.
6. Repeat the procedure until you achieve the hairstyle you desire. Allow your hair to cool down before
brushing it one last time.
7. When using the appliance, keep in mind that the ceramic plates are very hot.
8. Make sure your hair is entirely dry before beginning the styling process.
9. For easier hairstyling, divide your hair in the middle or along the sites into multiple segments, and apply
ahairpin to the segments you are not currently straightening.
10. Your hair may need brushing to make sure it is not tangled before straightening.
11. For shorter hair, place a brush in between the head and straightener to prevent the hot straightener
touching your skin. Do not use the straightener too close to your skin, ears and neck.
12. Switch the straightener o and disconnect from the outlet after use.
13. You can  nish your hairstyling by applying hair balsam. Rub the balsam in using your palms in acontinuous
motion from root to end.
CLEANING AND MAINTENANCE
• There are no components for the user to adjust inside the device, all repairs shall be carried out by
aquali ed repair centre!
• Disconnect the appliance from the electrical output prior to performing any maintenance.
• The appliance shall only be cleaned when cool; clean the appliance regularly after every use.
• Do not use aggressive cleaning agents or abrasive substances for cleaning.
• Maintain the hot plates clean, without dust, impurities, hair gels and sprays. Do not use together with hair
foam, spray, gel etc.
• Wipe the plates with adamp (not wet) cloth and dry with asoft dry cloth. Never clean the iron under
running water, do not rinse or immerse the iron into water!
Storage
• Always make sure the hair straightener is completely cooled, clean and dry before putting it away.
TECHNICAL DATA
Ceramic plates
LED power ON indicator
Very quick warm-up to max. temperature
Easy storage case
Nominal voltage: 100–240 V~ 50/60 Hz
Power input: 20–25 W