GB
19
USING THE APPLIANCE
This hair straightener has 3 control buttons:
ON/OFF
UP = higher temperature
DOWN = lower temperature
The temperature interval is 5°C.
1. Brush or form your moist or dry hair rst to remove any locks.
2. Plug the straightener into an outlet.
3. Press the “ON/OFF” button to turn the straightener on.
4. Press the “UP”/“DOWN” buttons to set the desired temperature of ceramic plates. Wait until the ceramic
plates to become warm enough.
5. Switch the straightener o and disconnect from the outlet after use.
Note: Using lower power is recommended for people with coloured, brittle, damaged and ne hair. To
save time and e ort, using the maximum amount of heat, established on the highest setting, is
recommended for people with healthy rough, strong, exotic and resistant hair.
USEFUL HAIR TREATMENT TIPS
• Straight hair
Insert about 5 cm of hair in between the ceramic plates, press the handle and slowly slide the hair straightener
from the roots to the ends.
• Fine curls
Insert about 5 cm of hair in between the ceramic plates, gently press the handle and slowly slide the hair
straightener to the ends; nally, wrap the hair around the plates.
• Outward curls
Insert about 5 cm of hair in between the ceramic plates, press the handle and slowly slide the hair straightener
from the roots to the ends and nally curl the ends out gently.
• Inward curls
Insert about 5 cm of hair in between the ceramic plates, press the handle and slowly slide the hair straightener
from the roots to the ends and nally curl the ends out gently.
CLEANING AND MAINTENANCE
Disconnect the appliance from the electrical output prior to performing any maintenance. The appliance
shall only be cleaned when cool; clean the appliance regularly after every use.
Maintain the ceramic plates clean, without dust, impurities, hair gels and sprays. Do not use the straightener
together with setting lotion, hair gel, spray, etc. Wipe the plates using a moist (not wet) fabric and dry with
soft dry cloth. Never clean the iron under running water, do not rinse or immerse the iron into water!
Always make sure the hair straightener is completely cooled, clean and dry before putting it away.
TECHNICAL INFORMATION
Continuous temperature control (up to 200 °C)
Nominal voltage: 230 V~ 50 Hz
Nominal input power: 100 W
To Next Page
Loading...