Echo 99944100010 - Assembly Instructions; Connecting Tubes and Nozzle Components; Connecting Kit to Blower Models

3
ASSEMBLY INSTRUCTIONS
1. Connect 2 long tubes (2) as shown in Fig. 1. Secure tubes
with clamp.
2. Connect 2 elbows (3) that make up adjustable nozzle. Fig.
2.
3. Install the adjustable nozzle to the small end of extension
tube as shown in Fig. 3.
4. Connect slotted end of straight pipe (2) to blower models as
follows:
• ModelsPB-210,210E,211:Connectslottedendofstraight
pipe (2) directly to blower housing. See Fig. 4.
• ModelsPB-46LN,46HT,60HT,400E,403,460LN,461LN,
260L, 261L, 600 TO S/N 505400, 601 TO S/N 505600, 6000
: Connect slotted end of pipe (2) to adapter (B). Connect
adapter (B) to blower swivel pipe.
• ModelsPB-200,201,2100,230LN,231LN,24LN,2400:
Connect adapter (A) to unit then connect kit to adapter with
clamp (1). See Fig. 5.
• ModelsPB-600S/N505401&UP,PB-601S/N506001&
UP, PB-602, 603, 610, 611: Connect adapter (A) to second
blower unit pipe then connect kit pipes to adapter with clamp
(1).
NOTE
Use only enough pipes to comfortably reach the inside of
the gutter.
Fig. 1
Fig. 2
Fig. 3
Fig. 4
Fig. 5
TO BLOWER
HOUSING
2
1
3
3
2
A
1