213 INCH CHIPPER/SHREDDER
ENGLISH
SERVICE & MAINTENANCE
WARNING
BEFORE INSPECTING OR SERVICING ANY PART OF THIS MACHINE, SHUT OFF POWER SOURCE,
AND MAKE SURE ALL MOVING PARTS HAVE COME TO A COMPLETE STOP.
5.15 LUBRICATION
Polyurea and lithium-based greases are not
compatible. Mixing the two grease types may lead to
premature failure.
WARNING
Do not over grease bearings. Overlling can lead to
excessive heat and/or unseating of the seals. Add
grease slowly and under light pressure. Whenever
possible, rotate bearing slowly while lubricating.
NOTE
Lubricate the machine periodically with a lithium-based grease. Extreme working conditions will require more frequent
greasing.
Grease the following points every 50-100 hours of operating time:
● Engine side bearing
● Chute side bearing
Figure 5.13, Chute Side Bearing Zerk
Figure 5.12, Engine Side Bearing Zerk (Bottom of Bearing)
To Next Page
Loading...