8
CS-3450
CS-3000
CS-3400
A
OPERATION
WHEN THE ENGINE IS COLD
• Move chain brake lever fully forward to engage chain
brake before starting.
• Fill the fuel tank with fuel.
• Fill the chain oil tank with lubricant.
• Turn switch (A) to “RUN” position.
• Pull choke (B) all the way out (close position).
• Push purge bulb (C) 10 times.
• Pull starter handle several times until first firing sound.
(Hold machine with your knee or foot.)
• Push choke (B) all the way in. (open position)
• Pull starter handle again.
WHEN THE ENGINE IS HARD TO START
• Press throttle control lockout down while holding
throttle trigger, and push in throttle control latch.
• Pull starter handle.
• When engine starts, immediately squeeze throttle
trigger to release the latch.
CAUTION
Clutch engages and chain will rotate when engine is started
with throttle control latch engaged.
After engine starts, release throttle trigger to idle engine.
Never use the throttle control latch for cutting.
Use only when starting the engine.
A
Securely hold the saw.
Make sure bar and chain are not touching anything when
starting the saw.
Do not pull starter rope out to the maximum possible
position.
Do not allow recoil handle to snap back against the casing.
B
C
To Next Page
Loading...
Need help?
General