OPERATION CS-4010
32 X7503380000
7/22 ECHO Incorporated
1. Move chain brake lever fully
FORWARD to LOCK chain brake
before starting.
2. Fill fuel tank with fuel mixture. Do
not over fill.
3. Fill chain oil tank with lubricant.
Do not over fill.
4. Push purge pump (A) 3 to 5
times or until fuel is visible in
purge pump.
5. Pull choke control knob (B) all the
way OUT (CLOSED [ ] choke
position).
◆ After choke control knob is pulled and then knob is
returned to original position, throttle remains slightly open
(fast idle latch condition).
◆ Chain will attempt to move when engine is started with fast
idle throttle latch engaged.
◆ Do not start engine before chain brake is locked.
6. Securely hold the chain saw and pull starter handle several times until
first starting sound.
7. Push choke control knob (B) all the way IN (OPEN choke position).
8. Pull starter handle to start the
engine.
Note: Do not pull starter rope out to
maximum possible position.
Note: Do not allow recoil handle to
snap back against the
casing.
Note: If engine does not start after
5 pulls, repeat instructions.
To Next Page
Loading...
