EasyManuals Logo
Home>Echo>Drill>EDR-260

Echo EDR-260 User Manual

Echo EDR-260
24 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #15 background imageLoading...
Page #15 background image
13
TROUBLE SHOOTING
Trouble
Engine - hard to start Cause Remedy
- does not start
Engine Fuel at No fuel Fuel filter clogged Clean or replace
cranks carburetor at carburetor Fuel line clogged Clean
Carburetor Ask your ECHO dealer
Fuel at No fuel at Carburetor Ask your ECHO dealer
cylinder cylinder
Silencer wet Fuel mixture is too rich Open choke
with fuel • Clean/replace air filter
• Adjust carburetor
• Ask your ECHO dealer
Spark at No spark at Ignition switch off Turn switch on
end of end of plug Electrical problem Ask your ECHO dealer
plug wire wire
Spark at No spark at Spark gap incorrect Adjust 0.6 to 0.7 mm
plug plug (0.024 to 0.028 in)
Covered with carbon Clean or replace
Fouled with fuel Clean or replace
Spark plug defective Replace plug
Engine Internal engine problem Ask your ECHO dealer
does not
crank
Engine Dies or Air filter dirty Clean or replace
runs accelerates poorly Fuel filter dirty Clean or replace
Fuel vent blocked Clean
Spark plug Clean and adjust/replace
Carburetor Adjust
Cooling system blocked Clean
Exhaust port/spark Clean
arrester screen blocked
WARNING
ALL ENGINE DRILL SERVICE OPERATIONS, OTHER THAN ITEMS LISTED IN THE
OPERATOR’S MANUAL, SHOULD BE PERFORMED BY AN AUTHORIZED ECHO DEALER.
FUEL VAPORS ARE EXTREMELY FLAMMABLE AND MAY CAUSE FIRE AND/OR
EXPLOSION. NEVER TEST FOR IGNITION SPARK BY GROUNDING SPARK PLUG NEAR
CYLINDER PLUG HOLE, OTHERWISE SERIOUS PERSONAL INJURY MAY RESULT.

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Echo EDR-260 and is the answer not in the manual?

Echo EDR-260 Specifications

General IconGeneral
BrandEcho
ModelEDR-260
CategoryDrill
LanguageEnglish

Related product manuals