Echo SRM-2620 User Manual

PAS-2620 OPERATION
X7502342503 25
© 07/20 ECHO Incorporated
5. Choke
After engine fires (or two to three pulls), move choke to the RUN ( )
(open) position. Firmly grasp throttle handle and throttle trigger lockout
with left hand and fully depress throttle trigger to wide open position. Pull
starter handle/rope (D) until engine starts and runs. Release throttle
trigger and allow unit to warm up at idle for several minutes.
Note: If engine does not start with choke in “RUN” position after 2-3
pulls, repeat instructions 2 - 5.
6. Throttle Trigger
After engine warm-up, grip throttle handle and support handle. Depress
the throttle trigger lockout, and gradually depress throttle trigger to
increase engine RPM to operating speed.
Starting Warm Engine
The starting procedure is the same as Cold Start except DO NOT close the
choke, and do not hold throttle trigger fully depressed.
The attachment should not move at idle, otherwise serious
personal injury may result.
Note: If attachment moves, readjust carburetor according to
“Carburetor Adjustment” instructions in this manual or see
your ECHO Dealer.
1. Stop Switch
Move stop switch button (A)
forward away from the STOP
position.
A

Echo SRM-2620 Specifications

General

Engine Displacement	25.4 cc
Engine Type	2-stroke
Carburetor	Diaphragm
Ignition System	Electronic
Fuel Mixture Ratio	50:1
Starter System	Recoil