10 English
TROUBLESHOOTING
Problem Possible Cause Solution
Line will not advance Line is welded to itself.
Not enough line on spool.
Line is worn too short.
Line is tangled on spool.
Spool in string head is not
installed correctly.
Lubricate with silicone spray.
Install more line. Refer to Line Replacement earlier in
this manual.
Pull line while pressing button.
Remove line from spool and rewind. Refer to Line
Replacement earlier in this manual.
If the string head has been disassembled for any reason,
make sure the side of the spool stamped with the letter
L is facing out when reassembled.
Grass wraps around boom
housing and string head
Cutting tall grass at ground
level.
Cut tall grass from the top down to prevent wrapping.
To Next Page
Loading...
Need help?
General
