Need help?Do you have a question about the ECKELMANN UA 410 L Series and is the answer not in the manual?
Lists and explains five essential safety rules for electrical work.
Warns about the sensitivity of electronic components to static discharge.
Outlines the process and requirements for updating the controller's firmware.
Details the steps to reset the controller to its factory default settings.
Details temperature recording requirements for EU Regulation DIN EN 12830.
Details the general installation procedures for the controller.
Explains how to mount the controller on a DIN rail.
Provides step-by-step instructions for mounting the controller on a DIN rail.
Guides on setting the unique CAN bus address for the controller.
Explains how to set the controller type using the DIP switch.
Details the step-by-step procedure for battery replacement.
Lists the necessary components and files for a firmware update.
Details the steps for installing the firmware update.
Provides specific instructions for updating controllers with a 9-pole DIP switch.
Provides specific instructions for updating controllers with an 8-pole DIP switch.
Offers solutions for common driver installation and USB connection issues.
Details the terminal connections for the 230 V AC power supply.
Shows the terminal assignments for the 230 V AC relay outputs.
Explains the operational modes for relay and transistor outputs.
Explains the high/low temperature alarm conditions and settings.
Lists electrical characteristics such as power supply, voltage, and current ratings.
General| Category | Temperature Controller |
|---|---|
| Series | UA 410 L |
| Input Type | Thermocouple |
| Output Type | Relay |
| Control Algorithm | PID control |
| Display | LED |
| Communication Interface | RS485 |
| Power Supply | 24 V AC/DC, 110…240 V AC |
| Operating Temperature | 0…50 °C |
To Next Page