WARNING
The saw chain has very sharp edges. Use protective gloves for safety.
1、Loosen the nut and remove the chain cover
2、Mount the guide bar then fit the saw chain around the bar and sprocket.(Photo 7)
WARNING
Pay attention to the correct direction of the saw chain(Photo 8)
3.Fit the chain tensioner unit into the lower hole of the guide bar, then install the chain cover and
fasten the mounting unit to finger tightness.
4、Adjust the chain tension by turning the tensioner screw until the chain sits comfortably and not
too tightly into the chain bar.(Photo 9)
(1) Tensioner nut
5、Mount the cover and tighten the knob securely. Then check the chain for smooth rotation
.(Photo 10)
To Next Page
Loading...
