Eckman EKPWT1 - Starting and Stopping the Engine

10
fuel lines and other engine parts.
STARTING THE ENGINE:
1.Move the choke lever upwards to the “cold start” position.(see Fig.9)
(Note: This is not required if the engine is already warm.)
2.Press the primer button 8 times, until the petrol flows in and out of the
discharge hose located above the fuel tank.(see Fig.10)
3.Pull the recoil starter 2-3 times until you hear the engine has “Bomb” sound
which is nearly starting. The engine may start, or it may be required to pull on
the recoil starter until the engine starts.(see Fig.11)
4. Move the choke lever downwards to the“run” position（warm start）.(see
Fig.12)
Fig.9
Fig.10
Fig.11