Troubleshooting
6-28 Algas-SDI Operations & Maintenance Manual P/N 52632
Typical Control Board
Figure 10 - Control Board Layout
Control Board.wmf
COMPONENT IDENTIFICATION
1. Typical Control Board Test Points
2. 6 Pin Molex Connector (for control panel lights J2)
3. Typical Board Adjustment Potentiometer
4. Typical Quick Disconnect Board Connector Points
5. Typical Board Lights
6. Operation / Fault Annunciator code (see annunciator code explanation)
7. 12 Pin Molex (for power ON switch, start button,
economy/auto-restart options J1)
8. Terminal Block (for thermocouple connections J4)
To Next Page
Loading...