Troubleshooting
6-42 Algas-SDI Operations & Maintenance Manual P/N 52632
Solenoid Valve Electrical Checks
WARNING
Turn off all power at the Main disconnect before proceeding.
Figure 19 - Solenoid Valve Electrical Checks (A)
Solenoid Electric Check (A).dxf
Remove cover on conduit "T". Pull the two red wires and remove the wire nuts.
Separate the wires and test the solenoid valve.
If it checks good, reconnect the wiring and do the same continuity check from the
control board position as shown on Figure 20.
OHM
To Next Page
Loading...