About Your Amplifier
Your Eclipse PowerAmplifier was Designed and Engineered
in
the USA for the best in
performance with the best components possible.
In
order to optimize the best
performance
of
your system, we recommend a professional installation
by
an authorized
Eclipse Dealer.
Power Supply: All Eclipse Amplifiers incorporate Powerful MOSFET Switching Power Supplies for
added reliability and powerful Music Reproduction.
Audio Amplifiers: The Eclipse Integrated Series use Symmetrical Analog Preamplifiers with Linear
Bi
Polar Power Stages for Musically Accurate Audio Reproduction.
Speaker Connectors: Flush Mounted Speaker Connectors allow Clean Installation with less risk
of
shorted wires. The speaker connectors will allow up to 10 Gauge wire interface.
Power Connectors: Eclipse Flush Mounted Power Connectors will accommodate up to 4 Gauge wire
for optimum power with very little Voltage Drop. As with the speaker connectors they provide less
opportunity for shorted conditions.
Fuse: Eclipse Power Amplifiers use ATC fuses. Do not replace blown fuses with fuses
of
a higher current
rating. This Amplifier requires maximum two 30 Amp fuses. (One 30 Amp fuse for EA2000 and two 30
Amp fuses for EA4000)
Eclipse Power On Indicator: When the Power Amplifier is powered on the Eclipse Brand Logo will
be Lighted.
Clipping Indicators: Each Amplifier has a clipping indicator LED located near the input gain control.
When the amplifier
is
clipping this indicator will light. This indicator will help you to adjust the input gain for
optimum performance.
-4-
To Next Page
Loading...
Need help?
General
