EasyManua.ls Logo

Eco Pacific Super Star SS Series User Manual

Default Icon
20 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Page #1 background imageLoading...
Page #1 background image
Eco Pacific/Super Star- Installation and Service Instructions, 2017
Installation & Service Instructions
for
Super Star SS and HB series (non-condensing)
High Efficiency Gas Ducted Heaters
(For internal & external installations)
(4.5- 4.8 star energy rated)
DO NOT MODIFY THIS APPLIANCE
Manufacturers of High Efficiency Ducted Gas Heaters,
Evap Coolers, and Fresh Air Heat Recovery Ventilators
Tel: (03) 9706 6228
Fax: (03) 9706 6089
Web: www.ecopacific.com.au,
Email: sales@ecopacific.com.au
(This document is copy-right protected and must not be used for
commercial purposes without expressed consent of Eco Pacific)
Question and Answer IconNeed help?

Do you have a question about the Eco Pacific Super Star SS Series and is the answer not in the manual?

Eco Pacific Super Star SS Series Specifications

General IconGeneral
BrandEco Pacific
ModelSuper Star SS Series
CategoryGas Heater
LanguageEnglish

Summary

Installation Instructions

Description of the Heater

Provides a general overview of the Super Star series gas ducted heating unit.

Models and Specifications

Details the different Super Star models and their technical specifications.

General Requirements

Outlines the essential requirements for installing the appliance as per regulations.

Inspection and Location

Guidance on inspecting the unit and selecting an appropriate installation location.

Clearances

Specifies the minimum required clearances around the appliance for safe installation and servicing.

Installation Procedure

Step-by-step general procedure for installing the Super Star heater.

Fluing and Gas Piping

Details on flue requirements and proper gas piping installation.

Electrical Requirements and Thermostat

Guidelines for electrical connections and thermostat installation.

Duct Connections and Air Ducting

Guidance on connecting supply/return air ductwork and warm air ducting.

Return Air, Filters, and System Balancing

Requirements for return air, filter installation, and system airflow balancing.

Pre-commissioning Checklist and Operation

Checklist before starting and instructions for operating the heater.

Diagnostics and Commissioning

Troubleshooting guide using diagnostics and steps for commissioning the unit.

Abnormal Operation, Warnings, and Maintenance

Guidance on abnormal operation, safety warnings, and routine maintenance.

Final Checks

A comprehensive checklist of final inspections after installation.

Service Instructions

Authorized Personnel and Cover Removal

Emphasizes servicing by authorized technicians and how to remove covers.

Service Diagnostics

Troubleshooting guide for identifying operational failures using PCB LED flash codes.

Overheat Switches and Pressure Switch

Explains overheat switches and provides guidance on the pressure switch.

Component Replacement: Ignitor, Sensor, PCB

Instructions for replacing the ignitor, flame sensor, and electronic control board.

Component Replacement: Gas Valve and Fan

Procedures for replacing the gas valve and combustion inducer fan.

Component Replacement: Fan Motor and Heat Exchanger

Instructions for replacing the supply air fan motor and heat exchanger.