6
Before the ride
• Tire pressure is within limits - tire manufacturers include
the required pressure information on the side of the tire
• Tires’ condition is good - check that there are no
deformations or cracks and that the tires are well aligned
to the rim and do not bulge out
• The wheels are attached firmly to the bike
• The handlebar and its stem are aligned, and do not feel
loose or turn on their own
• The seat is fixed firmly to the frame and does not rotate
or sag under the rider’s weight
• Both the front and rear lights are working correctly
• The bell is in working condition
• If your bike has V-brakes, check that the safety groove on
the side of the wheel rim is clearly visible. If it is not, the
rim must be replaced
• Both the front and rear brakes are working correct
Before each ride, inspect the technical condition of your bike.
Most importantly, you should check the following:
Preparing your bike for the first ride
Unpack your bike and accessories from the cardboard container.
Pay special care while unpacking to not scratch the bike frame
or damage any transmission cables.
Authorised dealers are obliged to prepare your bike for the first
ride in their shop. The dealer must enter the service details into
the user’s manual, under the section Warranty Card.
Important note:
Some of the components may have been disassembled before
packaging to facilitate transport.
To Next Page
Loading...