EN
6
Keep an appropriate distance between the refrigerator and surrounding objects.
Ensure at all times that there is a minimum of 2 in (50 mm) ventilation gap on all four sides
of the refrigerator. If the gap with the surrounding is too small, it will inhibit the refrigerator
from dissipating heat energy, resulting in a decrease in refrigeration capacity and an increase in
power consumption.
Install the refrigerator in a dry and well-ventilated place. Try to avoid direct sunlight on the
refrigerator.
• If the ambient temperature is too high, the refrigeration capacity of the refrigerator may
decrease and the power consumption may increase.
• If the refrigerator is installed in a place with excessive gas or smoke, the surface of the
refrigerator will have a color change.
Ensure that the refrigerator is disconnected from the mains before installing
and adjusting accessories.
to prevent discoloration. Please do not directly use the bottom tray that is placed under the
refrigerator upon factory delivery.
• Unstable installation will cause vibration and noise.
• The anti-tilt angle of this product is 30°. When the tilt angle is greater than 30°, the anti-fall
protection will be activated.
• Clean any dust accumulated during transportation of the refrigerator.
• Install accessories at the appropriate positions in the refrigerator, such as telescopic handle
(optional), wheels (optional), EFBX100-EB battery pack (optional), basket, temperature zone
divider.
To Next Page
Loading...