|21
En
Click to enter the corresponding house
address, and finally set the electricity rate.
a.Click to verify that the devices in the
device list match the connected devices.
If there is a firmware update available for the EcoFlow
PowerOcean system, the update page will pop up
to notify you when proceeding this step. The "Skip"
button is available for some update that is not
urgent. It is highly recommended that you upgrade
your PowerOcean firmware for seamless experience
immediately.
b.Set grid code, system work mode and feed-in power
limitation.
c.(Optional) You can also tapto set
Connection parameters, Voltage Protection parame-
ters, Frequency Protection parameters, Reactive Power
parameters and other parameters. (Please follow local
regulations, if you need to change any of these param-
eters, please contact your local power organization
first.)
d.Click to finish the commissioning.
To Next Page
Loading...
