2.5. Recommended positioning
Choose a dry place where there is no risk of frost. Avoid installation against bedroom walls or walls of other rooms where noise
emissions can be annoying. If possible, install the heat pump with the rear part pointed toward an exterior wall. Avoid installation
near a corner, since this can amplify noise emission levels.
The heat pump should be installed on a stable base that can support the total weight of the equipment and the operating fluids in its
interior. Use the adjustable legs to compensate for possible irregularities on the supporting surface.
Figure 1.6. Positioning and levelling the heat pump.
2.6. Service areas
The minimum recommended distances to be left around the heat pump to facilitate installation, start-up and maintenance work are
indicated below.
To Next Page
Loading...
