06022010
Manual Instrucons: Rotomolded Portable Foam Units | English
READ ALL INSTRUCTIONS BEFORE OPERATING EQUIPMENT
Safety Instrucons:
1.
2.
3.
measures.
4.
unplugging the air line from the unit and opening the HV60
5.
6.
when switching from an alkaline to an acid or an acid to an
alkaline.
Operaon Instrucons:
1.
2.
AP25.
3. Slowly open the HV60.
4. Adjust the NV14Y to desired wetness or dryness of foam
following the steps below:
turns.
Aer Use Instrucons:
1. It is recommended to run a gallon of fresh water through
discharged out the discharge hose.
2.
3.
system.
Maintenance:
periodically perform the following maintenance procedures:
1. Check the air pump for wear and leaks.
2.
3.
needed.
4. Drain compressor tank on a regular basis to ensure proper
Troubleshoong Instrucons:
1. Check for proper air pressure on air guage (AG100). Air
pressure is to be (50 to 60 psi (3.45 to 4.14 bar).
2.
Clean by unthreading the ABR25 from the R25.
3. Check for plugged STR34. Replace STR34 if necessary. STR34
must be used.
4.
due to lack of air pressure, if this occurs, reset NV14Y as
5.
being used.
6. If air passes through the P56 without cycling, replace P56.
7.
replaced.
8.
9. If the unit foams at a reduced pressure:
a. Check the air compressor supplying the unit. If the
the compressor can catch up.
AG100, which should read near 60 psi (4.14 bar). If the
AG100 is more or less than 60 psi (4.14 bar), adjust the
pressure by turning the knob on the top of the R25.
i. Be sure the foam unit is not plugged into an air supply
the SST12.
screen.
back of the tee and screw the hose barb back into the
tee. It is recommended to use a pipe thread sealant
when reinstalling the HBSS1234 into the SST12. If the
To Next Page
Loading...