Ecom Tab-Ex 01 D2 - Charging the Tablet Computer; Inserting the SIM Card (LTE Model Only) and Microsd Card; Repair

27
WARNING - EXPLOSION HAZARD - SUBSTITUTION OF COMPONENTS MAY
IMPAIR SUITABILITY FOR CLASS I, DIVISION 2
6. Repair
Repairs are to be conducted by ecom instruments GmbH or by personnel or
service centers authorized by ecom instruments GmbH only, due to the safety of
the device needs to be tested after repairs are implemented. The actual repair
report sheet can be downloaded from the service area at www.ecom-ex.com.
7. Inserting the SIM card (LTE model only) and microSD card
1. Remove the protective case and then the Rear Cover of the device.
2. Remove the battery from the battery compartment.
3. Insert the SIM card into the SIM card slot (LTE model only) and – if needed -
the microSD card into the SD card slot. Both slots are labeled.
4. Insert the battery again.
5. Attach the Rear Cover and make sure all mounts are rmly attached.
6. Attach the Protective Case.
8. Charging the tablet computer
Charging the tablet computer is allowed only outside hazardous areas!
The battery of the tablet computer is delivered not fully charged. It is recom
-
mended to charge the tablet computer’s battery for ve hours before using it
for the rst time. The full capacity of the battery is reached after 3 - 4 complete
charge / discharge cycles.
Note:
• There is a risk of explosion if the device is exposed to a ame.
• Only use ecom-approved chargers.
At the end of its lifetime, the supplied lithium-ion battery must be recycled or
disposed of separately from household waste. Don’t incinerate the battery.