Installation work should be done by certified technicians. Before setting up the machine and tables,
check first whether power line, drain line, water supply line and detergent/rinse tubes are connected
properly without any problems.
6.1 The straight-through installation
- Before hooking up plumbing and power lines, install the machine in the desired location and level
using the feet. Then run the detergent/rinse lines to where the chemical containers are located.
- After connecting the table to the machine, check that the door is moving up and down without any
interference between machine and table.
6.2 The corner installation
- For a corner installation only, move the rack guide rail from the front position to the side position.
Ecomiser SR-02 / SR-03 Manual 11/24 Page Rev.06
To Next Page
Loading...
