24
Adjusting the Rear Brakes (Right-Side Brake Lever)
1. Ensure that the scooter is safely parked using the double
kickstand (see page 15).
2. Using a 10mm wrench, loosen the bolt on the rear brake cable.
3. Gently pull the brake adjuster toward the centre of the scooter
(you may need to hold the brake cable to increase tension).
4. Tighten the bolt on the brake cable.
5. Press the right brake handle to test. If properly adjusted, the
brake handle should not touch the handlebar grip.
6. Ride your scooter for a short distance to test the brakes before
returning to normal use.
To Next Page
Loading...
