Suppliers Declaration of Conformity | Model #: Model # 70643, 70643-1, 70643-DK1 | Jasco Products Company LLC,
10 E. Memorial Rd., Oklahoma City, OK 73114 | www.byjasco.com
This device complies with Part 15 of the FCC rules. Operation is subject to the following two conditions: (1) this device may not
cause harmful interference, and (2) this device must accept any interference received, including interference that may cause
undesired operation.
FCC NOTE: The manufacturer is not responsible for any radio or TV interference caused by unauthorized modifications to
this equipment. Such modifications could void the user’s authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the
FCC rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This
equipment generates, uses and can radiate radio frequency energy, and if not installed and used in accordance with the instructions,
may cause harmful interference to radio communications. However, there is no guarantee interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
DO NOT put your ear next to speaker as it may cause hearing loss or damage.
Use of controls or adjustments or performance of procedures other than those specified herein may result in hazardous radiation
exposure.
• This is NOT a toy and not intended for use by children. Adult supervision is required at all times when children are nearby.
• Indoor use only. Do NOT expose this product to rain, moisture or water under any circumstances.
• UNDER NO CIRCUMSTANCES shall attempts be made to open the protective housing or operate the device if the product has
been damaged.
• Do NOT stare or look directly into the laser aperture as this can be hazardous and can damage your eyes. Intentional long-
term viewing of CLASS 2 levels of laser light can be hazardous. As with all bright light-sources, when you operate this device in
unsupervised general public areas, it is recommended that up-close access to the light be restricted or prevented and the beams be
directed into locations were persons are not expected.
• This laser display device incorporates a CLASS 2 laser system
which, by itself, may be hazardous. However, this laser display
optics in its design so that there is no exposure or human
access to laser radiation during operation or maintenance
above the CLASS 2 limits. The laser power is within the Class 2
limit of 1mW.
• This product is classified as a Class 2 laser product and
complies with the applicable parts of IEC/EN 60825-1 Ed.
2.0:2007 and Ed. 3.0:2014. The manufacturer additionally
certifies it complies with the US FDA Federal Laser Product
Performance Standard (FLPPS) provided in 21 CFR Subchapter
J, 1040.10 and 1040.11 except for allowable deviations specified
in FDA Guidance documents.
• LASERS SHOULD NOT BE POINTED INTO THE
SKY WITHIN 10 NAUTICAL MILES (18.5km) OF AN
AIRPORT. IF YOU ARE LOCATED WITHIN THIS
SPECIFIC PERIMETER, WE RECOMMEND THE
LASERS BE POINTED DOWN AT THE GROUND
TO PREVENT STRAY BEAMS FROM BEING
PROJECTED INTO THE AIR. CHECK WITH YOUR
LOCAL AIRPORT OR PROVINCIAL GUIDELINES FOR
FURTHER INFORMATION.
• It is the owner/operator’s responsibility to use this
device in compliance with local laws.
SAFETY WARNINGS
WARNING
• THIS PRODUCT IS NOT A TOY
• NOT INTENDED FOR USE BY CHILDREN
• USE INDOORS ONLY
• PLUG ONLY INTO USB SAFETY CERTIFIED TYPE A PORT
•THE INCLUDED USB CABLE SHOULD ONLY BE USED FOR
THIS DEVICE. IT SHOULD NOT BE USED FOR ANY OTHER LIKE
ITEMS, EVEN IF THE CABLE CAN BE INSERTED IN THEM.
• LASER LIGHT. DO NOT STARE INTO THE BEAM. CLASS 2
LASER PRODUCT. DIODE LASER-MAX. OUTPUT <1 mW.
WAVELENGTH 530-534nm.
FCC STATEMENT
LASER RADIATION
DO NOT S
T
ARE INTO BEAM
CLASS 2 LASER PRODUCT
CAUTION - TABLETOP LASER
Temperature ranges: -20° -40°C (-4°F-104°F)
Max output <1mW / IEC 60825-1:2014
Wavelength: 532nm
Manufacturer: JASCO PRODUCTS COMPANY LLC,
10 E. Memorial Rd., Oklahoma City, OK 73114
Product name: Tabletop laser projector
Beam divergence: 1.5mrad
Operating humidity: 10%~90%RH
COMPLIES WITH
21 CFR 1040.10 AND 1040.11
EXCEPT FOR DEVIATIONS
PURSUANT TO LASER NOTICE
NO.50, DATED JUNE 24, 2007.
Rating: 5V
2A max.
*RF warning for Mobile device:
ThisequipmentcomplieswithFCCradia
tionexposurelimitssetforthforan
uncontrolledenvironment.Thisequipme
ntshouldbeinstalledandoperatedwith
minimumdistance20cmbetweentherad
iator&yourbody.
To Previous Page
Loading...