FAULT DESCRIPTIONS
1. (00000001) Motor Controller Module Fault
The Motor Controller Module has found a memory error.
Primary Source - Motor Controller Module.
Action - Replace Motor Controller Module.
2. (00000010) Motor Controller Module Fault
An error has been encountered when trying to read the pressure sensor.
Primary Source - Motor Controller Module.
Action - Replace Motor Controller Module.
3. (00000011) Motor Controller Module Fault
The Motor Controller Module has found a memory error.
Primary Source -
Motor Controller Module.
Action -
Replace Motor Controller Module.
6. (00000110) Motor Controller Module Fault
The Motor Controller Module has received an incorrect signal from the pressure sensor.
Primary Source - Motor Controller Module.
Action - Replace Motor Controller Module.
7. (00000111) Display Module Fault
The Display Module has found a memory fault.
Primary Source - Display Module.
Action -
Replace Display Module.
9. (
00001001) Size Switch Error
The Display size switch setting does not match that stored in the memory.
Primary Source - Display Module.
Action
If the Display Module for model GWL03 has just been inserted into a console housing, then
check that the two size switch plungers accurately locate onto the console housing. If this fault
has appeared during normal operation of the machine, check the size switch or replace the
Display Module.
To Next Page