9
The POOL button tells Ecosmarte unit the maximum hours
your pool is running. The Ecosmarte unit will not output
outside of the programmed pool run time. Note: Pool Heater
must turn off 15 minutes before the pool to avoid plumbing
damage due to heat.
MAN will change the default from POOL = OXY to POOL =
ION. Ideal at new fill or when you wish to ionize today. Will
auto repeat, so you must press OXY when ION levels are at
reach.
The OXY button is used to setup the number of hours ox-
ygen your pool needs per day (Oxygen purifies water in
plumbing 6-10 hours per day).
NEXT/ENTER allows you to select future day for copper to
ionize your pool or to oxidize and ionize on the same day.
Will repeat each week if function is not turned off. This key
also allows completion of ALL programming tasks.
The ION/CU button is used to program the amount of cop-
per ionization that is delivered to the pool. Press ION to
change the start and stop times. Press OXY to stop ionizing
immediately when copper ppm is reached. At setup confirm
all settings after using this button.
ACC activates pool pump relay option, CO2 pH censor, a
visual or audio alarm for pH rance, and power to chambers
and CU sensors (when it becomes available). TDS and wa-
ter tempurature are future upgrades, as is remote computer
windows interface.
Your unit retains all values in the RAM programmed for 7
consecutive days without power to the box. No battery is
utilized.
PROGRAMMING MEMORY
To Next Page
Loading...