Ecotech TRT 60 - Preliminary Checks


ATTENTION!THELIFTINGPOINTFORTHEFORKLIFTFORKSISINDICATEDINTHEFIGURE!

4.2 STORAGE

Duringlongperiodsofstorageofthemachineitwouldbebestto:
 Emptythefueltankoffuel;
 Lubricatethecylinderwithasuitableproduct,availableatyourreseller;
 Cleantheairfilter;
 Emptyanyresidualgasolinefromthecarburettor;
 Grease any partswith
the paint worn off bywear or impact ofthe machine and any parts where the treatmenthas
wornofftoavoidpossiblerustformation.

4.3 PRELIMINARYCHECKS

 Checkthatallofthesafetyinstructionadhesivelabelsareinorderandlegible.
 Checkthatthemachineiscleanedofplantresidueanddebris.
 Checkthatallofthesafetyguardsandgrillesareinorderandingoodcondition

Beforestartingthemotor
 Visually
 inspect for any leaks and/or defective, missing or worn parts. See to any necessary repairs before using the
machineagain.
 Checkthattheoillevelisnotbelowtheminimum:unscrewtheoilfillercaplocatedontherearofthemotor;usinga
clean ragclean off the
dipstickand screw thecap backin. Unscrewthe cap againand makesure that theoillevel is
between the two minimum and maximum marks. If the oil level is below the minimum, top up to a suitable level.
(requestthepropermotoroilfromyourreseller)


ATTENTION!!!ANEWMACHINEISSHIPPEDWITHOUTMOTOROIL

 Makesurethatallofthescrewsareproperlytighteneddown.
 Makesurethatalloftheleversareintheirneutralposition.
Figure4‐2PositionofthelevelinNeutral

TRT60/TRT60Swing TRT110‐135/TRT110‐135Swing
 Righthandlebar Lefthandlebar

 Cleantheairfilterwheneverthereisfouling.
 Whenrefuellinguseafunnelwithafilterscreen,
 Openthefuelcockand,ifthemotorisequippedwithastarterdeviceonthecarburettoractivateit.
 To start the motor cold, position the gas lever in
the START position and wait a few minutes so the motor reaches
operationaltemperaturebeforetakingittomaximumspeed.
 Gripthepullstarterhandleandstartupthemotorwithastrongpull.


ITISRECOMMENDEDTHATYOUALSOFOLLOWTHEINSTRUCTIONSDESCRIBEDINTHEMOTORINSTRUCTION
BOOKLET.

Beforebeginningoperationsmakesurethatnopersonoranimalorthingiswithin30metresofthemachine;thenstartupthe
machinemotor.Oncethemotorhaswarmeduptakeittoits
maximumrunningspeed.