- the mode of data communications control with the PC;
- the mode of measurement results viewing stored in the nonvolatile memory (if
such results exist).
If the nonvolatile memory contains any measurement result, a short press of the
MODE button switches the radiometer from the mode of data communications control
with the PC to the mode of measurement results viewing stored in the nonvolatile
memory. By pressing the MODE button when the radiometer is in the mode of
measurement results viewing, you switch the radiometer to its initial mode – photon-
ionizing radiation DER measurement.
If the nonvolatile memory has no saved measurement results, a short press of the
MODE button switches the radiometer from the mode of data communications control
with the PC directly to the mode of photon-ionizing radiation DER measurement.
A short or a long press of the THRESHOLD button in any operating mode of
the radiometer changes the submodes of this operating mode. A detailed description
of each operating mode of the radiometer with its submodes is given below.
To Next Page
Loading...
