To Next PageTo Next Page
Need help?Do you have a question about the EcoWater ERRC 3502R50 and is the answer not in the manual?
General| Brand | EcoWater |
|---|---|
| Model | ERRC 3502R50 |
| Category | Air Conditioner |
| Language | English |
Identifies the original owner covered by the warranty and the process for claims.
Explains how warranty claims are handled and parts are replaced.
Details specific parts and their respective warranty durations.
Provides instructions on how to contact a local dealer for service.
Instructions for installing bypass valves and connecting copper tubing.
Guidance for installing a three-valve bypass system.
Instructions for connecting the inlet and outlet plumbing.
Detailed steps for connecting the water inlet and outlet pipes.
Procedures for testing leaks, programming the controller, and rinsing.
Instructions for filling the brine tank with water and salt.
Connects the system using the router's WPS button for wireless setup.
Connects the system using a web browser on a computer or mobile device.
Finalizing system configuration and settings after network connection.
Steps for dealers to register a new customer system online via the EcoWater website.
Procedure for adding a conditioner/refiner or other device to the remote.
Adjusting the scheduled time for automatic recharge cycles.
Procedure for removing a device from the remote's configuration.
Describes the screens shown during normal conditioner/refiner operation.
Prevents unauthorized changes to operational parameters.
Procedure for setting the salt level on the electronic control.
Initiating a manual recharge to ensure adequate conditioned water supply.
Procedure to set or change the current time on the unit.
Adjusting the scheduled time for automatic recharge cycles.
Inputting the water hardness level for optimal system performance.
Inputting the iron level in the water supply for compensation.
Adjusting the duration of the backwash cycle.
Choosing the operating mode (Salt Efficient, Auto Adjusting, High Capacity).
Programming or resetting the service reminder interval.
Accessing the diagnostics screen to check component operating states.
Repeating setup or restoring default operating values.
Guidance on refilling the brine tank and setting the salt level.
Basic checks to perform before proceeding to advanced diagnostics.
Explains the unit's self-diagnostic function and error codes.
Procedure for manually checking component states via diagnostics screen.
Verifies operation of valve positions, brine draw, and recharge flow.
