3.2 LED Indicator
Flash (each): Indicates one packet of RF data
from a sensor was received or one lightning
strike was detected.
Flash (for 2S): Indicates detection of noise
signals, prompting the user that current
location has high level noise. You can either
set dip switch 3, 4 to mid or low sensitivity
level which raised to a higher threshold level
for noise filtering, or you can find another
location for lower noise level.
Steady on (for 2S): Indicates detection of
interference signals. It means there is lightning
like signals around. You should try to find
interference sources like motor, switches for
all kinds electrical appliances, and place the
To Next Page
Loading...
