MT-206/MT-207 Trolley Installation Guide
- 1 -
WARNING
1 Assembling or disassembling of the Trolley should be performed by service
personnel authorized by the manufacturer.
2 The maximum load of the top splint is 8 kg. Do not put heavy objects on it
or lean on it.
3 The overall check of the Trolley, including the safety check, should be
performed only by qualified personnel once every 6 months, and each
time after fixing up.
4 The Trolley and accessories are to be disposed of according to local
regulations after their useful lives. Alternatively, they can be returned to the
dealer or the manufacturer for recycling or proper disposal.
5 Use a crosshead screw driver to secure all the screws tight when
assembling the Trolley.
CAUTION
When adjusting the stand post, be careful not to trap your fingers.
NOTE:
1 The following figures take M3 for example. The Trolley can also be used
for M3B, iM9 series, iM8 series, iM50, iM60, iM70, and iM80 monitor by
using a proper link board.
2 Make sure the casters can rotate normally before the setup.
3 Make sure the Trolley is firmly assembled and is in good condition before
applying the monitor to it.
To Next Page
Loading...
Need help?
General