Page 12
SECNG-I-1217
800-638-3326 • edcoinc.com • techsupport@edcoinc.com
EQUIPMENT DEVELOPMENT CO., INC.
ATTACHING A VACUUM / SERVICING HEAD ASSEMBLY
PROCEDURE FOR ATTACHING A VACUUM:
If using a vacuum for dust control attach it to the
vacuum port at the rear of the machine which is
on the handle as pictured above, securing it with
clamps. The port is shown in the above photo.
FOR LUBRICATION:
Grease ttings are now available through access
port in hood.
To Next Page
Loading...
