BEFORE YOU PLUG IN
Bass amplication embraces a mixture of technologies in amplication and to ensure you achieve the maximum
performance from your cabinet and amplier it is important to ensure you combine the right equipment for your
needs.
Hybrid and non all tube product*
These products can often operate at a variety of loads (known as impedance) this load describes the resistance
provided by the speakers inside the cabinet you plug into. As a general rule the lower the impedance an amplier
is used at the higher the output of the amplier will be (Excludes All Tube Product) To ensure you choose the
right cabinet make sure that it meets both the Impedance requirements and the power handling (Wattage) of your
amplier. Plugging into the wrong impedance or combining the wrong amplier with a cabinet that cannot handle
the power you put through it can damage the amplier, or cabinet or both.
All Tube Product* This applies only to those ampliers which utilize tubes in power stage of operation. Generally
these are describes as All Tube or All Valve products.
When choosing cabinets to use with all tube ampliers it is important to remember that you must strictly follow the
load of the amplier specied by the manufacturer. Failure to do so can and very often will result in the failure of
the power amplier stage of your product which is something which can be very expensive to repair. As a general
rule most bass products have xed impedances to plug into. Make sure you read and understand this before
plugging into a cabinet. If in any doubt contact the manufacturer before you turn your amplier on.
To Next Page
Loading...