Do you have a question about the EdenPURE Wall-Hugger and is the answer not in the manual?
Improper use of the heater can result in fire, electric shock, and injury to persons.
Service other than filter maintenance must be done by an authorized representative to avoid voiding the warranty.
Do not open the heater; there are no user-serviceable parts inside.
Change between Fahrenheit and Celsius scales by pressing and holding QUIET/LOW, then using TIMER to cycle.
Set the heater to power on automatically after a specified number of hours (1-12 for GEN2, 1-24 for Wall-Hugger).
Set the heater to turn off automatically after a specified number of hours (1-12 for GEN2, 1-24 for Wall-Hugger).
Upgrade kit available; GEN2 may show 'Replace UV Bulb' without kit.
Press the QUIET/LOW button to operate the unit at a lower noise and power level.
Clean the washable lifetime filter with warm tap water; do not force dry.
On GEN2, press and hold PURIFIER for 5 seconds to reset the 'Clean Filter' notification.
Wipe the cabinet clean with a soft damp cloth.
Unplug, wind cord, cover, and store in a dry, low dust environment for extended periods.