Edge ED71200 - Set up Section; Troubleshooting

Troubleshooting
● Before removing the amplier, refer to the list below and follow the suggested procedures.
● Always test the speakers and conrm that they are wired correctly rst.
● If in any doubt get help from a qualied auto electrician.
Amplier Will Not Power Up
● Check for good ground connections. Ensure Ground cable is connected directly to bare
metal and not a painted surface.
● Using a multimeter check that remote terminal has at least 10V DC.
● Using a multi meter check that there is battery voltage on the positive terminal.
● Check all fuses.
● Check that the protection light is not illuminated. If it is lit, shut off the amplier for thirty
seconds and then turn it back on.
Protection LED Illuminates When Amplier Is Powered Up
● Check for shorts on all speakers wires. (IE no speaker wires should be joined together and
no speaker wires should be touching the cars chassis)
● The amplier is designed to shut down automatically when the units temperature goes
above 80 degrees. If the amplier feels very hot then this may be the reason for the
amplier not starting.
● Remove the speaker wires and reset the amplier. If the protection LED still comes on then
the amplier is faulty. This damage may have been caused by either failure to follow these
setup guidelines or abuse.
Amplier Gets Very Hot
● Check the minimum speaker impedance for the amplier is correct.
● Check for shorts on all speakers wires. (IE no speaker wires should be joined together and
no speaker wires should be touching the cars chassis)
● Check that there is good airow around the amplier. In some applications an external fan
may be required.
Blown Fuse(s)
● Check both positive supply and ground for shorts.
● Check that the positive wire is connected to the positive terminal on the amplier.
● Check that the negative wire is connected to the ground terminal on the amplier.
● Ensure that the correct rated fuse is tted
Distorted Sound
● Check the gain control is not set at too high a level. If the speakers sound distorted turn the
down the gain until the sound is clear.
● Check that all crossover frequencies are correct. See setup section for more details.
● Check for shorts on all speaker wires.
● Check all speakers are wired correctly. With the correct polarity being observed on each
connection.
Set Up Section
To correctly set the gain control of the amplier to match that of the source (headunit) use the
following setup routine:
Turn the gain control to minimum on the amplier.
Ensure the bass boost is set to 0 dB.
On the headunit set all crossovers to at and both bass and treble to zero.
Turn up the source (headunit) to approx 3/4 volume.
Very slowly turn up the gain on the amplier until distortion can be heard in any of the speakers
or until the volume reaches an uncomfortable listening level when this is reached turn down
the gain control slightly.
The gain control is now set.
The setting of the crossover will depend on what kind of speaker you are installing.
For a subwoofer it is recommended that the crossover is set to Low Pass and the frequency is
set to match that of the speakers specications.
For a pair of full range speakers it is recommend that the crossover is set to Flat. The two
frequency controls will then have no effect on the ampliers output and the speaker will receive
a full range signal. However, using the high pass crossovers will allow more control of your
speakers. By removing the bass (low frequencies) the speakers can perform at higher volumes
with less distortion.
Note: The smaller the speaker, the less bass it can handle. Adjust the crossover to get the
most and best sound from your speakers. The easiest was to do this is by limiting the amount
of bass you feed them
For a pair of speakers with a passive crossover it is recommended that the crossover is set to
High Pass and the frequency is set to match that of the speakers specications.
Note:
By using the crossovers correctly you will not only lengthen the life of your speakers but
you will also get better performance from them. To optimise your setup seek the advice of a
professional installation engineer or visit your local EDGE audio dealer.