Edge EDB12A User Manual

Run in procedure
EDGE recommends that you follow the run in procedure for the subwoofer
detailed below.
When your Subwoofer is used for the rst time, like most brand new items
it is naturally very stiff and rigid. It will take time for the moving parts of this
Subwoofer to loosen up before the Subwoofer will be ready to deliver its full
potential.
For the rst 30 hours it is recommended that you play the Subwoofer initially
at low to medium volumes, gradually increasing the volume level as time
progresses.
As a guide, if you listen to your Subwoofer for 1 hour every day it will take a
month for the subwoofer to run in properly.
You will notice a big change in the sound of the Subwoofer over this period.
As the spider and surround begin to run in the sound will get deeper and
harder, also the output of the Subwoofer will increase as the suspension
loosens up.
The Subwoofer is like your car’s engine, it needs a few thousand miles
before you can drive it to its full potential. Driving it into the redline from
the rst day will mean engine damage is certain and will not be covered by
warranty.
Failure to follow this simple procedure is the most common reason for a
Subwoofer to fail after a very short period of time.
Installation
The most common place to mount a bass enclosure is in the luggage
compartment of the vehicle.
Where in the luggage compartment it is mounted will have an effect on the
sound produced allowing the user to tailor the sound to best suit their musical
tastes.
For example if the enclosure is mounted facing the rear bumper, the bass
produced will be noticeably deeper than if it is red into the rear seat.
class ab monoblock amplifier
ED7200
class ab monoblock amplifier
ED7300
20A
ED7300-E1 (125 watts use on EDB12TA only)
ED7200-E1 (75 watts use on EDB12A, EDB10A only)
ED7200-E1
ED7300-E1
POWER WIRING
Mounting Guidelines
Your EDGE enclosure is designed with a swift installation routine in mind.
Please mount it in a dry location on a solid surface. NEVER mount the
enclosure at such an angle that the amplier is upside down, this will cause
the amplier to over heat and will eventually damage the entire unit.

Edge EDB12A Specifications

General

Brand	Edge
Model	EDB12A
Category	Car Speakers
Language	English