EdgeStar AP13500G - Operating Instructions; Control Panel Overview

17
F0
NA
Low refrigerant
charge due to leak
or defect.
 Find leak and repair.
 Recharge refrigerant.
H3
NA
Compressor
overload protection.
 The coils are dirty or the air inlet or outlet is
blocked. Clean coils and/or move/remove
obstructions.
 Fan is not running or set too low. Increase fan
speed or replace fan if defective.
 Compressor is defective. Replace compressor.
 Refrigerant leak. Repair leak and recharge system.
 Restriction in refrigeration system. Locate and clear
restriction, then recharge refrigerant.
 Water flinger motor defective or fly wheel
obstructed. Clear obstructions, repair alignment of
motor or replace if defective.
H8
LED blinks
eight times
then off for 3
seconds.
Condensate water
overflow protection.
Water reservoir is
full.
 Water reservoir full. Drain water from unit.
 Level switch stuck or being interfered with. Remove
any obstructions from water tray and/or unstick
switch. Make sure switch is free to move as water
level changes.
 Loose or disconnected switch wiring. Repair
connections.
 Level switch is defective. Replace switch.
 Main PCB is defective. Replace PCB.
E5
LED blinks
five times
then off for 3
seconds.
Overload
malfunction.
 Unstable power supply voltage or supply voltage
too low. Requires certified electrician to adjust
supply voltage to within proper operating
parameters.
 The coils are dirty or the air inlet or outlet is
blocked. Clean coils and/or move/remove
obstructions.
 Fan is not running or set too low. Increase fan
speed or replace fan if defective.
 Compressor is defective. Replace compressor.
 Restriction in refrigeration system. Locate and clear
restriction, then recharge refrigerant.
E8
NA
Overload
protection.
 The coils are dirty or the air inlet or outlet is
blocked. Clean coils and/or move/remove
obstructions.